Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Put the power of your system in the palm of your hand. Adjust any brand of air springs (sold separately) from inside or outside of your cab and run diagnostics with the hand-held controller or your smart phone. Includes EZ Mount for no-drill install.
Features:
Specs:
Oh, the power of your index finger. Air Lift's premium, wireless, onboard compressor system with Bluetooth allows you to fill your air springs at the touch of a button. WirelessAIR also automatically maintains pre-set air pressure levels.
With the Air Lift mobile app and your smart phone, you can inflate or deflate your air springs and even run advanced diagnostics without leaving the driver's seat. Additionally, it includes a wireless controller if you would rather use a traditional remote. The system lets you know if there is a leak or if the compressor has malfunctioned. If you want to get a good look at your vehicle while adjusting your air springs, just grab your controller, hop out of your truck and make your adjustments from outside the cab.
As soon as you turn on WirelessAIR, the compressor will activate and fill your air springs to the default level of 5 psi. After that, you can reset your default pressure settings to whatever you like (between 5 and 100 psi) and WirelessAIR will maintain these levels for you, staying within 3 psi of your desired level. Built-in digital air pressure gauges allow you to monitor each spring on your vehicle. You can pre-program two pressure levels for frequently carried loads such as your boat or camper. Also, WirelessAIR senses when your air pressure falls below a safe level and restores pressure to the minimum psi, preventing wear on your air springs.
WirelessAIR has a dual-path controller that lets you adjust two air springs individually. This means that you can get front-to-back and side-to-side leveling. Alternatively, you can configure the system to adjust and monitor two pairs of air springs independently. This way you can put different amounts of air into your front pair and rear pair of springs, allowing you to level your vehicle front to back.
The system comes complete with everything needed for installation, including an air compressor; a manifold; an easy-to-install wiring harness; and a wireless, hand-held digital controller. It also includes the EZ mount for a simple, no drill installation. This mount comes with the compressor and manifold pre-installed on the bracket and clamps to the frame using a U-bolt.
WirelessAIR is compatible with any brand of air springs, and it comes with a 2-year limited warranty.
Alternate Instructions
California residents: click here
Average Customer Rating: 4.7 out of 5 stars (260 Customer Reviews)
Put the power of your system in the palm of your hand. Adjust any brand of air springs (sold separately) from inside or outside of your cab and run diagnostics with the hand-held controller or your smart phone. Includes EZ Mount for no-drill install.Installed on a 2023 GMC 3500 Denali CCLB. Not much experience but I an a little handy. Pre-installation - watched the etrailer video. While installing I watched the video again step by step. Make sure you watch the video into the next step of install before proceeding w/the previous step. It will make your install more clean. Product works great.., phone app & remote paired & connected perfectly. Thanks for the install video & very satisfied with the product. All wiring, tubing & misc. parts were included.
Wouldn’t have bought airbags without this. I can control it via my phone.
Robin
3/21/2024
My husband loves it because he controls it from his phone
Pulling a fifth wheel RV trailer, and a gooseneck trailer on the farm, the airlift bags, along with the onboard compressor has made pulling either trailer safer due to the leveling ability this kit allows.
Customer service from etrailer was great with making sure I received the exact kit for my truck.
Five stars for sure!
Easy install, works great. Nice having the ability to adjust bags as needed on the fly.
Great product and service from the team at etrailer.
easy to install. Push a button, and raise airbag pressure, push another button let out pressure, pretty much wish i had spent the money on this system for my previous truck. I may fabricate a little metal shield to go over the compressor and solenoid/bluetooth package to keep mud and salt off them. I installed compressor behind storage bump out thing to block spray from from tires. I still have to install compressor air intake filter, i am going to install it inside that little storage compartement so compressor always gets fairly fresh cab air.
Joseph
4/3/2021
ridonculous! this thing is awsome. i dump a load on the hitch, then bump up pressure till headlights shine about where they were shining with no load. works pretty darn good.
Premium priced kit with compromises; the wiring loom is poorly constructed and isn't wrapped in flex housing or any protection (none is provided either), the air lines provided are very cheap and don't seal well in the air fittings. additionally there are some features missing from the kit "due to supply chain" while it was kept at the same price it was previously. not impressive for a xxx$ kit.
This airlift system works as advertised. Installation was simple. The wireless remote with presets is great. I have presets for 10 psi, 50 psi and 100 psi. One push of a button and I am ready for most all the loads that I haul.
2020 GMC 2500. Did LoadLifter 5000 and EZ compressor set up.
The exhaust runs down the passenger side and the fuse box with switched power signal is on the driver side so for multiple reasons I wanted to mount the compressor on the driver side. I couldn’t do inside the rail as I would have preferred given all the DEF and fuel tanks. Above the frame rail running down most of the truck are 2 solid brake lines that would interfere with the U bolt to mount the EZ compressor assembly vertically as I originally intended. I did find a space I could fit it in without interference with those lines but it hung low and was more visible and exposed that I preferred. I did find though 2 existing holes in the frame that the U bolt fit in perfectly for a horizontal mount without interference and much higher and better tucked up under the truck for a super clean mount. The U bolt threads didn’t run deep enough for a single frame wall mount so for $3, I bought steel spacers and after painting them inside and out for corrosion resistance, I mounted very easily for a “customized” no drill $3 option. There is also a large wire harness that runs from that spot all the way to the battery so it was easy to run my wires along side and attach to that all the way up. Very happy with that location as air lines were easy to run and plenty long from there as well and put in 2 service loops just in case.
I ended up running the pink wire to the fuse box and bought some fuse splicer wires Iike in the etrailer video. Hesitated to trim the fuse box on my brand new truck so the lid would close and like to keep mods as unnoticeable as possible so wanted to see how well it performed just based on motion and waking with the remote or app. I’ll wire it later if needed but just left it tucked for now.
I also picked up some Daystar airbag cradles and mounted those to bottom bracket using the existing center hole in the bracket. Just picked up longer SS countersink bolts and hex nuts. No drill but I did have to trim the bolts off for a perfect length. Now the stretch of the airbag doesn’t limit suspension travel down and I don’t have to worry about bag damage when on a service lift down the road. Obviously when under its own weight or loaded the bags fit snugly and are well supported by the cradles. Outside of the time to buy the additional hardware that took zero additional time and is much preferred as now I can take it to the shop without worry. The only draw back is they are 6” cradles and I would have preferred the 7500# air bags for extra duty but they are 7”. I run the same setup on my 2002 Excursion and knew for sure I wanted the cradles so stayed with 5000# bags. I’m not loading a skid steer in the bed so really that should be plenty.
Love the AirLift system and have ran them for years. Glad to have them installed on my new truck and look forward to the next load.
Put pics of bags with suspension full droop, and then under normal weight. Also pics of the mounting location and final mounted compressor set up and look from side of truck.
Would recommend this set up for anyone who uses their truck like a truck and would recommend these minor mods on the install.
After a year the unit has worked as advertised I've not had a issue with it. I did have to take the compressor out of the mounting kit to install it on the 2019 F-350 I couldn't find a place to mount the EZ mount. other that that I've been very happy with it. I did mount the compressor with a vibration dampener works well I don't hear any vibration in the cab of the truck also I made a stand off for the controller so I would not have to move a brake line.
Great to be able to adjust both airbags or either in isolation from the cab of my truck or from the rear of my truck camper as I’m leveling at the campsite. This is a pricey option but worth the investment in convenience value!
Lawrence
4/13/2023
The onboard compressor and Bluetooth remote have performed well over the past year, though I have had a few occasions where the compressor generated an error message and I had to pull the fuse in the engine compartment and re-set. The compressor also doesn’t like cold weather so when I’m Winter camping I don’t try to use it unless temps are well above freezing. Otherwise it has help up fine and made for a great addition to the airbags.
Great system with easy install. Unfortunately remote broke well before the year mark. Hopefully their warranty process isn’t too cumbersome. Problem with the remote failing is there might not be any other way to charge up your system. I had to remove the fuse to let air out of the bags manually at one point. Other than the remote system works well and hasn’t failed.
Should’ve put this on my last 2 trucks, it’s pricey but worth it. I’ve had it a year pulling a 5th wheel, works great!
I had bought a new F450 truck to haul my new truck camper. I had bought everything I needed from E-Trailer. Hitch, tie downs, and air bags. I absolutely love the air bag system. Worth every dime. I can raise the rear of the truck, so it will be level. I haven’t had any problems with anything. I definitely would, invite anyone who is hauling a large camper, to invest in air bags. Everything was installed at E-Trailer in Wentzville, MO. A absolute professional.job, done well. Thank you E-Trailer. From a happy camper.
I put on my F250 Diesel and it works like a dream. I pull a 13,000 pound fifth wheel camper and trailer with skid loader on it on the rear hitch. My truck does does not squat with the 20# of pressure and pulls like a dream.
Air Lift makes a very nice easy to install system. Took me about 3 hours to install including the Air Lift Wireless Air Compressor System.
I did not notice a change in drivability or handling, that was never an issue but how the truck rides is amazing when loaded. Riding on an Air Cushion taking the load off the secondary springs makes it feel like the truck is unloaded.
At the push of a button the truck is at ride height. The headlights are no longer pointing at the stars.
I like your product so much I am ordering a system for my Dually.
It has worked out great for me
Quick connect clamp would not go around frame. Drilled and tapped holes to mount.
I've had this air lift system on my 2007 Tundra with a cabover camper in the bed for a year now. Works as designed. Fantastic product!
George
1/12/2023
To this day, this air lift system has worked flawlessly. Great product.
outstanding product, works great. could use 2 to 4 for meet of hose so you don't waste time finding the right route to take for hose installation because you can run out of hose if you're not precise. but a great investment.
Milton
3/6/2023
the entire system works great together. the bluetooth app is very simple to use. outstanding product.
Great company to do business with, cheapest place in town to order towing parts. Thanks, the airbags and wireless compressor is working great. Haven’t got to use the auto slider hitch yet.
So nice to have the compressor on board so I can change pressures on the fly. Works great!
After 2 winter seasons my compressor has completely failed. It will not turn on at all
Heather A.
4/26/2022
I am happy to assist you with the airlift compressor not working. When you use the remote do you hear a clicking sound from the manifold? Do you get any type of error code when you try to use it? I also recommend to test the wires from the compressor with 12 volts to see if the compressor runs. If it does, there may be an issue with the wireless controller. If it doesnt, the whole unit may be bad unless it is a relay. If you can answer those questions to start I can assist you further.
Works well and holds air extremely well
Works great install was easy mounted under hood to keep salt and brine off also used braided line so far zero issue.
Awesome pair up with the 7500XL bag kit. Only down side I have found is there is not a “Off” option. So the pump randomly kicks on even when the truck is turned off as to maintain the 5psi safety setting. With the factory springs still in place, I don’t see why it is necessary to maintain 5psi in the bags. If the truck were parked for a long period of time, this could become a drain on the truck batteries. Just my two cents. I’d still buy the kit again.
Do you have a question about this Air Suspension Compressor Kit?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Kenneth P.
3/4/2024
Still working great after a bit over a year using the product. Very satisfied with the productpurchase